[KantusKrixus]

Hello, I just recently purchased a great running v92c and noticed that the previous owner had installed Led lights in the rear fender, however didnt install any turn signals or license plate light. Wires are cut off a couple inches from the plug.

My question is do I need load resistors to install led turn signals on the rear?

 

[walks35]

For my 04 Kingpin I put an LED Relay in the headlamp bucket for the signals. No load resistor needed. I'm not sure this applies to your v92c but on the Kingpin (at the time) Polaris reversed the polarity of the wiring and didn't and say or do anything about it. Spent several hours being p1ssed off only to find out. You might test that out.

Congrats on the ride and welcome!

 

[KantusKrixus]

For my 04 Kingpin I put an LED Relay in the headlamp bucket for the signals. No load resistor needed. I'm not sure this applies to your v92c but on the Kingpin (at the time) Polaris reversed the polarity of the wiring and didn't and say or do anything about it. Spent several hours being p1ssed off only to find out. You might test that out.

Congrats on the ride and welcome!

I guess I'll just have to test as I go. I figured the leds might cause the hyper flash problem I've always seen happen in other vehicles/motorcycles. Might order a couple just incase I do need them.

Thanks!

 

[FNG]

Did you ever do the LED's? I am fighting a 2000 V92c switched to all turn signals led and installed resistors and it is still hyper flashing. I have tried every color combo and can not slow down the flashig.