[Netnorske]

I replaced the lenses in the light kit I bought from Arizona Victory. The top photo shows the lenses they sent me in the kit, the bottom photo is the new light lenses I installed. They are Adjure 4.5" Diamond Cut Ice Spotlights. They really match the front headlamp welland look like they were MADE for the Victory. I am still using the same 35W H3 bulbs from my original setup as they were all wired and still working well. I was looking for some sealed beam bulbs when I stumbled onto these. This look is so nice though that I could not pass them up...!!

 

[TheTazman]

...I may have to save my bike bling $'s or this set-up

 

[tonygiotta]

Nice, that really makes them look like a Victory accessory rather than an afterthought. Have you had a chance to ride with them at night? Do they put out a good pattern?

 

[Netnorske]

Nice, that really makes them look like a Victory accessory rather than an afterthought. Have you had a chance to ride with them at night? Do they put out a good pattern?

I try not to ride at night unless I have to, so I can't say. I generally have them on all the time though....the more lights the better.

 

[Prairie_Cruiser]

Kris, those look really nice! You're right, they match the headlight perfectly.

 

[Kingfish]

Is it just the glass lens that swaps out? How easy is the change out? They look great!

 

[Netnorske]

Is it just the glass lens that swaps out? How easy is the change out? They look great!

Just pull the outer ring off the mainlightand the inner light housing falls right out. The actual H3 bulb is attached through the rear of the inner housingwith a small screw. Once you remove that screw, you can pull the bulb out (but do not touch it with your bare fingers) and replace thelight housing with the new Adjure housings. I think the H3 bulb is held on with a spring on the new housings. Shove the light housing back into the main lightand replace the outer ring. Voila!