[Squatch]

I am a proud member of the "can't leave well enough a lone" club. There are a few of you on this forum.

Been a wire comms guys for 20 years. My 2013XCT has wired comms and a CB. Riding with my Gold Wing buddies I use the CB for bike to bike comms. Riding with anyone else we either use hand signals or they use Bluetooth.

I have stepped up and purchased a set of Sena 20 BT comms units. Great stuff and they connect to My Zumo, my phone, each other and others in the Bluetooth comms world. It doesn't connect back tot eh bike and allow use of the CB. OK Need the dongle and the harness but that replaces the wired /CB comms harness. So back to the start of my post, can't leave well enough alone, I am looking for a way to connect the CB into the comms path of the Bluetooth.

Figure I need the harness and dongle.
Next up need the wiring diagram for both the wired harness and the Bluetooth harness.

I should be able to identify the key line, mic input and CB output to the comms system.

What I figure I would do is wire these into the dongle and as dedicated CB comms so I can have the best of both worlds.

Anyone have the wiring diagrams for the wired and the dongle systems?

 

[Squatch]

OK... lots of noise on this subject... So off I go.

 

[nakota7]

Start on pg 549 of the manual. It talks COM input.... Good luck!

 

[RoteBarron]

I'll do some looking. Keep us posted if you would.

 

[RoteBarron]

Don't know if this helps: (26pin Bluetooth connection)...

 

[Kenstah]

Seems to me there was another thread on here about incorporating a CB. If you haven't purchased the radio yet see if there's one that has Bluetooth or an adapter and Sena should be able to connect no sweat!

K ;-)