VOG Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
463 Posts
Discussion Starter · #1 ·
ok I have a 2011 XC triked out 6 years ago

Cruise works just fine until.... I turn a signal on then it kicks out the cruise as if I touched the brake.
Unfortunately no clue where to start looking ,all lights work and flash normally front and rear

Any advise from the pros...appreciated

Thx
 

·
Registered
Joined
·
8,141 Posts
Just a guess here, but it sounds like voltage is somehow crossing over to the brake circuit and tripping the cruise. With everything being LED my guess is a flasher relay, or if aftermarket fog lights then possibly their connection. I would disconnect any non stock wiring first to see if that fixes it. Does it have trailer hitch wiring?
 

·
Registered
Joined
·
4,559 Posts
I'm in 100% agreement with @primethious. My first thought would be "is there a run/brake/turn module or trailer harness/isolator installed?"
 

·
Registered
Joined
·
463 Posts
Discussion Starter · #4 ·
Thant might be it... there is He way under the trunk, maybe I should just replace it to start. The fog lights run all on their own wiring and not tapped into anything

Thx
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top