VOG Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Hey y'all. I've been searching forum threads about blinker issues after installing aftermarket LED strips and have yet to find an answer.

Problem: After installing new 6-node LED strips for use as turn signals I'm having two main issues..
1. All lights are blinking quickly when using signals/hazards.

2. Both sets of signals (left & right) will blink a time or few then stop and remain on as a solid light. The right more so than the left has this issue. I turn them off and back on and the problem repeats .

I've read of people using end of line resistors, voltage regulators, etc., etc. But haven't found a solid answer or suggestion on this.

If I need resistors, what ohm rating? Voltage regulator? Brand & size?

Hoping someone can come through for me here . Thanks in advance!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top