[Wikkedjestr]

I just bought a 2005 victory hammer and has cobin dual seat that i want to take off but cant seem to find how its even bolted down. Want to put the factory seat back on it.

 

[jmstang302]

Pull the side covers off under the seat. There are 3 pins in rubber grommets, pull straight out. One Allen bolt on each side.

 

[Wikkedjestr]

Tried pulling up but seemed like it was bolted down somewhere at the back side of driver part of seat. Dont see any bolts on the sides anywhere

 

[Wikkedjestr]

Does it pop out of the grommets pretty hard

 

[PJRo]

check under the rear fender ..... there should be 4 bolts that attach to the seat.

Peter

 

[PJRo]

the original factory seat attaches from the top side of the rear fender , under the rear cowl.

the seat you have will attach from under the rear fender.

Peter

 

[Spacecoast]

I have the Corbin Smuggler seat which is the same rider portion as your Dual Tour....light years better than the stock seat. FYI

 

[Wikkedjestr]

The main reason i want to get the seat of is to get at wiring as the previous owner butchered up the turn signals and has some leds the im not sure work so i want to get that all out or see whats up with all that. See what kind of programmer it supposedly has. Got to wait for a warmer day to dig into it a bit more. Thanks for the replys and ill try all suggested. I do see 2 bolts coming into the bottom of fender but doesnt look like they r nuts look more like part of the fender