VOG Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
151 Posts
I was looking into lowering them but the wife said they are good.
I was going to make a new set of mounts so they would be lower.
you would think they would at least offer something to lower them.
Due to the mounting and not knowing what the metal is making a different type is the only way as I see it. Would not be that hard mind you but it would be time consuming.
 

·
Registered
Joined
·
3,394 Posts
So far the only successful lowering has been done by taking off the mounts and having them shortened by a machine shop. That involves cutting, welding and painting.
 

·
Registered
Joined
·
332 Posts
mjw930 said:
So far the only successful lowering has been done by taking off the mounts and having them shortened by a machine shop. That involves cutting, welding and painting.
I was able to get it done about a month ago. There are some tricks to it (mount removal, etc.), but it's not at the top of the difficulty scale. I did have some help with welding the aluminum. Most say that 2" is too much. I cut them 1", but wish I had gone for 1 1/2"
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top