VOG Forum banner
1 - 1 of 4 Posts

· Registered
12,150 Posts
willorlando said:
1. Do I just unbolt the left side bolt? The bike will be on the kickstand, so will my wheel move when do this?

2. Do I need to remove the seat to get to the wiring?

3. Any tips from someone that already installed one of these.
1. make sure your adjuster bolt is snug before you loosen the nut and you will be fine.
2. I jacked mine up by the frame to get to the wiring. It was a pain in the butt but I did not want to remove the fender. With that said I'm not sure on the JP
3. Just make sure your wiring is tight and will not hit any moving parts.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.