VOG Forum banner

How to remove stock grip chrome end caps

8504 Views 10 Replies 4 Participants Last post by  willorlando
Hi, I scraped up the left side end cap on my stock grip (clutch lever side).I ordered a new one already.How do I take off the Chrome end cap and put the new one on?
1 - 11 of 11 Posts

· Registered
Joined
·
59 Posts
Check out this page there is a video on here to show how to remove end caps and put on their locking caps but will help out for what you need.
http://victoryaccessories.com/
video is about half way down page. If it doesn't show up just look for the kewllock item 231.

James
 

· Registered
Joined
·
45 Posts
Discussion Starter · #7 ·
Yep, channel lock or vise grips, grab old one and justroll the capback and forth to loosen andgradually pull out. I used a rubber hammer with a rolled up thick microfiber cloth and pounded on the new one.No glue is needed, the newcaps haveridges thatcrush when you install them keeping the cap on tight. I used a little bearing greaseon the install.Part was $15 plus shipping online.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top