VOG Forum banner

Factory 2" pullback bars - Looking for heads up tips before install

7K views 19 replies 13 participants last post by  PuddleDuck 
this is a very easy install if you are handy with working on macanical things just make sure that you cover the tank up with a couple of towels next cut off the left hand grip loosen the allen bolts for the controls then unbolt the bars / then take the allen bolts out of controls and slide the throttle side off first then the clutch lever side it will be tight but it will slide off each end then reverse the steps !! hope this will help it took me about 1.5 hours .
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top