VOG Forum banner

Carbon Fiber

11661 Views 54 Replies 24 Participants Last post by  Brookshirebrother
Instead of blacking out some of the light grey aluminum, I decided to Carbon Fiber Wrap. Not too difficult of a job, but you need a little patience.



1 - 1 of 1 Posts

· Registered
Joined
·
1,194 Posts

I'm not sure if this would apply, but when I used to apply decals to my company vehicle, I would use a water bottle filled with water and a little bit of dish soap. I would spray down the surface and the glue side of the decal and apply. The soapy mixture would allow me a few minutes to play around with the position of the decal. Once I got it set, I just use a credit card to squeegie out the water and air bubbles.
Not sure if this is even applicable. Just an FYI.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top