[Dvldogg187]

i was riding down a bumpy residential street today when I heard a bolt bouncing next to my bike. I'm not sure if I rode over it or if it fell off, does this look familiar to anyone?

 

[vision_nut]

looks like the pin that holds your brake pads in place. If so its missing the little rubber O-ring on the end

 

[BP6666VR]

Typical victory pin, used for foorpegs, foot master brake cylinder, etc etc .... But 4,5 " long ????? Never seen that ...

The brake calipers retaining bolt looks completely different ... Jas a threaded end on 1 side, and a funny looking ball & notch on the other side

But there is a SLIDING pin with rubber boot inside the brake caliper that is 2" long ....

Sorry i cant help to indentify the locking pin ....

 

[Redsawacs]

Looks like my house door hinge pin

 

[Dvldogg187]

I appreciate the input you guys, thank you. I’ve checked and checked and didn’t find anything missing. Maybe it’s just junk I ran over.

 

[primethious]

It looks like the pin that attaches floorboards.
Don't throw it away until your 100% sure it's not needed.

 

[timtim]

Were you following behind a Harley ? lol

 

[PreachSF]

at over 4" long .. that is nothing for your highball .. it almost looks like a footpeg pin, but its way too long to be that

 

[Fox Fader]

Were you following behind a Harley ? lol

Good one!

 

[Dvldogg187]

Thanks for chiming in everyone, I’ll just throw it in my spare bolt bin and not worry about it.