VOG Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results
  1. Tech Q&A
    Hi everyone. So I am (attempting to) installing a set of RPW Slash pipes to my Highball. And I have a question about the rear exhaust mount. So after I remove the old exhaust, the swingarm pivot bolt/nut looks like this: There is a little spacer part which sits over the nut that held on the...
  2. Victory High-Ball
    I have RPW Slash pipes installed on my High Ball, and I've been troubled by the heat given off of them. I wrapped them in the hope that would help, but it was only a very small improvement. Recently I installed a couple of DEI heat shields, and the improvement is more than I expected. So far I...
1-2 of 2 Results
Top