vision_nut | Victory Motorcycles: Motorcycle Forums
vision_nut
Last Activity:
May 10, 2020
Joined:
Aug 15, 2011
Messages:
7,877
Trophy Points:
113
Positive ratings received:
2,602
Neutral ratings received:
155

Post Ratings

Received: Given:
Like 746 78
Agree 1,015 13
Disagree 155 9
Funny 336 7
Winner 218 1
Informative 204 0
Useful 83 1

Share This Page

vision_nut

Moderator

Staff Member Moderator
vision_nut was last seen:
May 10, 2020
    1. Flyboy
      Flyboy
      Hey Visionut, what are you disagreeing wih in Miles to empty? Just curious...
    2. 30yearbreaktoVision
      30yearbreaktoVision
      What does wikipedia 2011 Victory Vision "Carry over" mean when referring to 2011 Vision?
      Did they Carry over the styling from 2010 or everything? I heard engine was improved to 5000 mi oil change from 2500.
    3. garbear
      garbear
      I did adjust it a little but not quite 1/8". Thanks. Have a good weekend.
    4. arkvic
      arkvic
      hey vision-nut, thanks for responding, my vision is stock height.i saw that witchdoctors has a lowering rod/link. but I heard that they knock out/crack up the inside of the bags. is that true, or is tghat just a load of b.s someone was slingin'?? thanks again
    5. crosscountryla
      crosscountryla
      I think I have my hydraulic clutch dialed in now. I should have put a plastic grocery bag over the hole in the frame that's right behind the gas tank. My problem now is that I dropped one of the inside rubber gromets down the hole in the frame. I disconnected two plug in's that were inside of the hole so I could see better, and then moved my drop light right over th hole ,but can't see the rubber groment any where.
    6. shane-at-ness
      shane-at-ness
      I have the vision shields in stock, 29 on hand. It measures 14"
      1. vision_nut
        vision_nut
        Tell Cory we want 16 inch ones to.
        Thanl You
        Oct 22, 2012
    7. shane-at-ness
      shane-at-ness
      I have the vision shields in stock, 29 on hand. It measures 14"
    8. visionriderdeluxe
      visionriderdeluxe
      Nut, I still need to get a lowering kit for the front correct. I wouldn't trust a weld job on the rear i would purchase the lowering kit, better safe than sorry. Thanks.
  • Loading...
  • Loading...
  • About

    Type of Motorcycle Currently Riding:
    vision 08
  • Loading...